Could anyone tell me which models this propstand fits please
Announcement
Collapse
No announcement yet.
Trials propstand
Collapse
X
-
Hi,
My prop stand, 1960 Scottish, was made by a GRA Member.
The problem was it was about an inch to short to work.
Had to screw an inch by inch square tube, at the bottom, to work.
Guess it depend if the suspension is standard or not.
I remember the GRA supplying stand measurements at the time.
Are Parts still available ???? as I'm missing the spring, and curved part,
whitehillbillies
-
Originally posted by whitehillbillies View PostHi,
My prop stand, 1960 Scottish, was made by a GRA Member.
The problem was it was about an inch to short to work.
Had to screw an inch by inch square tube, at the bottom, to work.
Guess it depend if the suspension is standard or not.
I remember the GRA supplying stand measurements at the time.
Are Parts still available ???? as I'm missing the spring, and curved part,
whitehillbillies
Comment
-
Trials propstand
I think the stands are about the same for the TDS TES and TFS as well but heights do very a little, I found that the angle of lean was a bit different so some fine tuning is required.
I never use the stand at all in trials as they all ways sink in mud or topple over!
Comment
-
As per my thread & drawing by 'buzzer' here http://www.greeves-riders.org.uk/for...4092#post24092
Comment
-
£91!! with a few tools some scrap steel tube & sheet & an ark welder you could make one for a lot less than that. The drawing is up on the other thread
Last edited by John Wakefield; 26/03/2015, 09:50 PM.
Comment
Comment