Gentlemen,
I know... I know... I know... I know... I should have taken a photo before taking it to bits, then I would not have to ask these questions.
Please see photo attached of reassembly so far.
Please could somebody confirm that the square tab with a hole in it on the end of the black wire (which I'm going to replace/renew)
goes under the nut on the thingy that holds the end of the contact breaker spring and the steel connector to the capacitor ?
And does the end of the wire from the coil go under the nut on the end of the capacitor ?
Probably better if the wire from the coil goes inboard of the coil and not close to the spinning rotor ?
Thank You
Martin
I know... I know... I know... I know... I should have taken a photo before taking it to bits, then I would not have to ask these questions.
Please see photo attached of reassembly so far.
Please could somebody confirm that the square tab with a hole in it on the end of the black wire (which I'm going to replace/renew)
goes under the nut on the thingy that holds the end of the contact breaker spring and the steel connector to the capacitor ?
And does the end of the wire from the coil go under the nut on the end of the capacitor ?
Probably better if the wire from the coil goes inboard of the coil and not close to the spinning rotor ?
Thank You
Martin
Comment