If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Ok I hope I don't get a slap on the wrist for not searching for this (I tried) but how much slack should there be on my 250 Griffon drive chain? I'm use to modern MX bikes with a ton of slack so could use some help on this one.
Ok I hope I don't get a slap on the wrist for not searching for this (I tried) but how much slack should there be on my 250 Griffon drive chain? I'm use to modern MX bikes with a ton of slack so could use some help on this one.
hi John thought you were referrimg to primary drive chain . For main chain again at tightest point with somebody sitting on bike to need and middle finger between chain and point it meets swinging arm. 1.5 to 2 in max . On my Griffons I dispensed with stock guide and fitted one off a pre 2007 yz250 f .... If u do that you can run with more slack in the chain
Hi John, I have always set up a new bike like this,
put bike on a stand,
remove rear shocks
set swinging arm at position when chain is at it's tightest,
turn wheel to ascertain tightest spot
set chain with half to three quarters of an inch of free play,
tighten up spindle and replace shocks
cut a block of wood to sit on arm and take up play,
make sure you can repeat acurate position of wood
chuck it in your tool box and use it for quick and easy chain adjustment
works on modern or old bikes, hope I remembered everything.
Good luck and a happy new year, Steve
Hi John, forgot to mention, make sure you line up rear wheel carefully whilst setting up, measure from rim to s,arm each side and just to make sure use a straight edge or a length of string to line up front to rear wheels. Regards, Steve
Last edited by Steve Cooper; 31/12/2015, 01:02 PM.
Reason: forgot a bit
One gent I know bought one of the laser devices that can be attached to the rear sprocket and directed to the front one. On quite a lot of bikes, he finds the alignment is out if you use the given marks or snail cams. On comp bikes this is normally due to a slight set having been introduced into the frame or swing-arm during a bad landing. On road bikes, he looks for accident damage to account for similar problems!
One gent I know bought one of the laser devices that can be attached to the rear sprocket and directed to the front one. On quite a lot of bikes, he finds the alignment is out if you use the given marks or snail cams. On comp bikes this is normally due to a slight set having been introduced into the frame or swing-arm during a bad landing. On road bikes, he looks for accident damage to account for similar problems!
Comment