Pathfinder-help required.

[Charlie]

Hi,
I am trying to re-build a Pathfinder from a box of bits and am struggling with some of the cables. I am not convinced the ones I have are correct for the machine - they are new but don't seem to fit. Is there any chance anyone could post some photos close up of attachments to clutch, front brake and decompressor so I can see the components and then tell if I am missing bits or have wrong cables.
Alternatively if anyone has a Pathfinder in the Surrey / Hants border area that I could look at that may be a big help.
Thanks for any help youay be able to give.
Charlie.

[Robert]

Pathfinder

Hello,
do you still need informations?
I have a Trial and an Enduro Greeves Pathfinder with a 175ccm Puch engine.
Regards
Robert

[Brian Thompson]

Welcome!

Hi Robert, and a warm welcome to the forum!

Good to have another of our friends from overseas on here, and thanks for posting your offer of help with Charlie's Pathfinder.

Brian.

[Charlie]

Pathfinder

Hi Robert,
Thanks for your response. I think I have the cables sorted now but the other thing that is confusing me is that the front wheel seems to be off-set due to the speedo drive and I can't see that there is any room for a spacer or washer on the other side to correct this - so is this normal? (Mine is a trials bike.)
Thanks,
Charlie.

[Bearingman]

Hi Robert,
Thanks for your response. I think I have the cables sorted now but the other thing that is confusing me is that the front wheel seems to be off-set due to the speedo drive and I can't see that there is any room for a spacer or washer on the other side to correct this - so is this normal? (Mine is a trials bike.)
Thanks,
Charlie.

Charlie,

Here is a pic of my Pathfinder front wheel. I hope this helps.

Regards,
Ken Sykes

[Robert]

photos

Hello,
please send me your mail adress. Over the weekend I will take photos from my bikes and will mail them to you!
Do you know where I can buy original cables for my Greeves?
I always like to have a set of cables in my pocket!
Regards from the sunny and hot alps!
Robert

[Bearingman]

Pathfinder clutch cover

Hello to all.

Any of the Pathfinder owners know the proper procedure to install the clutch cover on a Puch? I can't get the clutch to engage.

I do know the flat portion of the release guide and shaft face towards the front.

I do not have a Puch manual.

Thanks!
Kenny Sykes
USA:

[Bearingman]

Pathfinder clutch cover

Hello to all.

Any of the Pathfinder owners know the proper procedure to install the clutch cover on a Puch? I can't get the clutch to engage.

I do know the flat portion of the release guide and shaft face towards the front.

I do not have a Puch manual.

Thanks!
Kenny Sykes
USA:

I figured it this A.M.

KS