If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
5/8" UNF is the answer to your question. Technically, they should be half nuts. Historically, Unified fine nuts were marked on the flat with a series of overlapping circles. Can't imagine you will have too much difficulty in obtaining some in Aus. I use stainless steel on my TFS with a nylon insert.
Regards
Phil
Last edited by Phil Hyde; 06/02/2013, 07:43 AM.
Reason: More info
Comment