Hi,
Cut from 10mm chopping board a round chain tensioner.
Before I drill the inner casing, is it a good idea ????
I was going to seal and bolt it up, to take some slack out, as the chain is not that old. ( sure someone will say put a new one in. ) But has stretched a bit.
Also some chain wear on the outer cover at the bottom.
The mainshaft ???? that hold the clutch basket, moves in and out 2mm maybe 2.5mm.
What needs shiming, adjusting to take this play out, or is it ok ????
Thanks for the replies.
whitehillbillies
Cut from 10mm chopping board a round chain tensioner.
Before I drill the inner casing, is it a good idea ????
I was going to seal and bolt it up, to take some slack out, as the chain is not that old. ( sure someone will say put a new one in. ) But has stretched a bit.
Also some chain wear on the outer cover at the bottom.
The mainshaft ???? that hold the clutch basket, moves in and out 2mm maybe 2.5mm.
What needs shiming, adjusting to take this play out, or is it ok ????
Thanks for the replies.
whitehillbillies
Comment