Some advice please. Would like to check the timing on the Electrex ignition unit on the 32A engine in my Scottish. Dont think there is a problem but would like to eliminate it from the possibilities.
I have the instruction/installation leaflet supplied which shows the timing marks etc. As I did not install the unit personally I had not seen under the outer cover until today. As many of you will by now have guessed you cant see the timing markes with the outer flywheel fitted. So presumably I have to take the outer flywheel off to be able to see the marks. Will the engine run correctly without the flywheel? If not how is it done please. Thanks in anticipation of your considered responses.
I have the instruction/installation leaflet supplied which shows the timing marks etc. As I did not install the unit personally I had not seen under the outer cover until today. As many of you will by now have guessed you cant see the timing markes with the outer flywheel fitted. So presumably I have to take the outer flywheel off to be able to see the marks. Will the engine run correctly without the flywheel? If not how is it done please. Thanks in anticipation of your considered responses.
Comment