If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Thanks Colin. Now I know that a roller type bearing won't fit. Nobody makes one that size. That bearing is still the weak spot in an otherwise good clutch. A standard ball race should not be subjected to axial load. The more the gears are changed when using the clutch lever the quicker that bearing gets more slop in it.
Hope you are in good fettle.
Regards,
David.
Last edited by 46T Sprocket; 08/02/2019, 11:42 AM.
Comment