If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I had these made up some years ago...the Griffon pictured is my 250.
I had two type made up...one for the Stefa type crank and a Motoplat version for a friends late model Griffon.
These were one off and I'm sure I can have more made. They also made one up for my Pathfinder and I then added a very heavy steel weight which helped a lot. A woodruff key is not used with this setup.
If I recall someone took the design and was selling them on EBAY over on your side. Sending cases and cranks to Germany wasn't cheap, but was happy with the results.
I emailed powerdynamo to enquire and they were very helpful. Although these systems are discontinued the main parts can be purchased.
I bought a stator, back plate, ignition coil, reg/rec, rotor and puller from them.
The rotor came with a pilot bore which I machined to suit the Greeves crank taper, the housing requires some machining to suit the backplate and a ring making and pressing on to enable the larger motoplat type cover to be fitted. I opted to make a complete new housing.
The complete set of parts including tax and delivery was 219 euros
Comment